The bdk flag BDK_SDMMC_UHS_DDR200_SUPPORT can be used to enable it.
SD Card DDR200 (DDR208) support
Proper procedure:
1. Check that Vendor Specific Command System is supported.
Used as Enable DDR200 Bus.
2. Enable DDR200 bus mode via setting 14 to Group 2 via CMD6.
Access Mode group is left to default 0 (SDR12).
3. Setup clock to 200 or 208 MHz.
4. Set host to DDR bus mode that supports such high clocks.
Some hosts have special mode, others use DDR50 and others HS400.
5. Execute Tuning.
The true validation that this value in Group 2 activates it, is that DDR50 bus
and clocks/timings work fully after that point.
On Tegra X1, that can be done with DDR50 host mode.
Tuning though can't be done automatically on any DDR mode.
So it needs to be done manually and selected tap will be applied from the
biggest sampling window.
Finally, all that simply works, because the marketing materials for DDR200 are
basically overstatements to sell the feature. DDR200 is simply SDR104 in DDR mode,
so sampling on rising and falling edge and with variable output data window.
It can be supported by any host that is fast enough to support DDR at 200/208MHz
and can do hw/sw tuning for finding the proper sampling window in that mode.
Using a SDMMC controller on DDR200 mode at 400MHz, has latency allowance implications. The MC/EMC must be clocked enough to be able to serve the requests in time (512B in 1.28 ns).
Since there are some bootloaders that mess with the states of some power gpios, reorder gpio configuration for input/output in order to prevent power pin glitches.
- Management of sd init done is now on sd init retry function
Also manages inserted, since it can set the sd init done to false if failed
- Init will now always check if SD is also initialized, since it doesn't manage it anymore. Because of that, mounting is no longer forced, but checked first.
- Unmount/End will now always set the sd as unmounted, since no data residue is expected after the fact
The above will improve handling of faulty SD cards or faulty SD readers.
In case of FS corruption or SD issues, do the following:
- Try 2 times to init SD.
- Try 2 times to load resources
- Fatal if fail with an error message.
- Fixed an issue where cached data would not be flushed after setting the fw carveout. Now they are flushed before setting it.
- Fixed and off-by-one bug and setting incorrect number of mtc entries.
