CTCaer
b3be7e7a41
bdk: display: use the same HS exit threshold
...
No need to use minimum on T210.
Use the same byte clocks as T210B01 to simplify init.
2024-06-02 08:11:22 +03:00
CTCaer
26c6c6372d
bdk: display: rename window setup arrays
...
Add window number info and remove the fb naming
2024-06-02 08:05:50 +03:00
CTCaer
28eb3f4bcd
bdk: display: deduplicate array size macro
2024-06-02 08:02:44 +03:00
CTCaer
bd55a3e756
bdk: clock: always set DISPA source
...
No need to distinguish between LP or HS.
Setting the same value doesn't glitch.
2024-06-02 08:00:42 +03:00
CTCaer
b01cc2432f
bdk: irq: remove ack source
...
HW interrupts can't be managed by FIR.
Only actual hw can clear the interrupt.
2024-06-02 07:46:18 +03:00
CTCaer
05db43a97c
bdk: hwinit: move down debug uart init
2024-06-02 07:44:22 +03:00
CTCaer
859811a154
bdk: fatfs: update copyright
...
Last edit was in 2022.
2024-06-02 07:42:35 +03:00
CTCaer
6b54c4a477
bdk: usb: hid: don't send a packet if no new data
...
Reduce the interrupt caused at the host side
2024-06-02 07:40:11 +03:00
CTCaer
9d79af231e
bdk: use static where it should
2024-06-02 07:09:34 +03:00
CTCaer
84c5439c70
bdk: usb: utilize apb relaxed clocks for init
2024-06-02 07:01:31 +03:00
CTCaer
8c44969afb
bdk: blz: refactor style
2024-06-02 06:51:47 +03:00
CTCaer
7a74761da9
bdk: bpmp: add and use bpmp_clk_rate_relaxed
2024-06-02 06:51:06 +03:00
CTCaer
14706cef4e
bdk: minerva: add emc src div disable
2024-06-02 06:46:28 +03:00
CTCaer
93296c2c38
bdk: joycon: add packet size checks
...
Pass the real received data size and do the proper checks for minimum info.
2024-05-19 17:42:10 +03:00
CTCaer
a070d2e394
bdk: ums: allow real sizes for boot partitions
...
Since that's eMMC, do not clamp the size to 4MB.
That doesn't affect anything other than allowing the host to see the whole
physical partition .
2024-05-19 10:57:20 +03:00
CTCaer
927489d2da
bdk: add missed defines
2024-05-19 10:50:25 +03:00
CTCaer
ae29f359ee
bdk: hwinit: rename reinit_workaround to deinit
2024-05-19 10:49:25 +03:00
CTCaer
7af343dd6c
bdk: input: make joycon detection more robust
...
There's a hw bug on the gpio controller that can latch the last value on reads.
Mitigate that by reading once to unlatch the input value.
Also actually allow sio to be polled every 8ms.
2024-05-19 10:19:25 +03:00
CTCaer
547a3542ee
bdk: display: add more defines
2024-05-19 10:16:52 +03:00
CTCaer
4bc0a0591c
bdk: display: wait 2us for bl pwm config to take
...
Fixes the tiny blink showing up while pwm is still at max.
2024-05-19 10:15:52 +03:00
CTCaer
985c513770
bdk: hwinit: add arbiter config
2024-05-19 10:07:06 +03:00
CTCaer
16eb6a3c44
bdk: types: do not overflow on byte swaps
...
Addresses warning message.
2024-04-25 16:57:43 +03:00
CTCaer
856994e4f4
bdk: sprintf: add right padding support
2024-04-25 04:56:38 +03:00
CTCaer
ec2e62236a
bdk: pinmux: add i2s pin config
2024-04-25 04:52:13 +03:00
CTCaer
2648a2655c
bdk: sdram: add info about custom 8GB T210 config
...
That's a suggestion on which 4GB modules are certainly fine to use.
2024-04-25 04:50:07 +03:00
CTCaer
62153fdfbb
bdk: types: add likely/unlikely global macros
2024-04-25 04:48:09 +03:00
CTCaer
28960728f9
bdk: joycon: add bit numbers on the button struct
2024-04-25 04:46:27 +03:00
CTCaer
902ccede9a
bdk: joycon: use proper bits for batt levels
2024-04-25 04:45:50 +03:00
CTCaer
96efa7a002
bdk: vic: add support for P8 and R5G5B5
2024-04-25 04:44:22 +03:00
CTCaer
d92906db5e
bdk: display: correct some reg names and add more
2024-04-25 04:44:08 +03:00
CTCaer
e8d6516f43
bdk: display: use basic profile for OLED
...
That's the one with the accurate sRGB colors.
Anything else is over saturated.
2024-04-25 04:38:57 +03:00
CTCaer
a6727f6e32
bdk: display: update active regs on vsync for WinD
...
Doing that on hsync can cause issues on disable without actually syncing to it.
2024-04-25 04:38:04 +03:00
CTCaer
e846f4576e
bdk: minerva: l4t: adjust sdmmc1 la and freq table
...
- LA is tightened up
- Copied frequencies are now 204/408/800/1333/1600/OC (from 204/666/800/1600/OC)
2024-03-29 13:21:53 +02:00
CTCaer
42c02e97e8
bdk: display: add 6.2" panel clone
2024-03-29 13:21:53 +02:00
CTCaer
d687b53249
bdk: heap: add zalloc and utilize it
2024-03-27 09:00:53 +02:00
CTCaer
9e41aa7759
bdk: smmu: refactor and update driver
...
- Allow ASID to be configured
- Allow 34-bit PAs
- Use special type for setting PDE/PTE config
- Initialize all pages as non accessible
- Add function for mapping 4MB regions directly
- Add SMMU heap reset function
- Correct address load OP to 32-bit and remove alignment on SMMU enable payload
- Refactor all defines
2024-03-14 09:21:06 +02:00
CTCaer
9ba7c44b89
bdk: clock: use real source clock dividers
...
Use CLK_SRC_DIV macro in order to have the actual divider showing.
2024-03-13 02:01:01 +02:00
CTCaer
9a520d63a6
bdk: smmu: refactor driver and allow other asid
2024-03-13 01:54:46 +02:00
CTCaer
20e661fc01
bdk: refactor flow control defines
2024-03-13 01:50:45 +02:00
CTCaer
3a4fa12f42
bdk: smmu: powergate ccplex after enabling smmu
2024-03-13 01:44:58 +02:00
CTCaer
fb31cb2926
bdk: ccplex: add no rst vector lock & powergating
...
Allow not locking the reset vectors and launch a new payload after powergating ccplex.
2024-03-13 01:37:52 +02:00
CTCaer
f126486266
bdk: sdmmc: utilize block size defines
2024-03-12 15:47:14 +02:00
CTCaer
25b7ffecd1
bdk: fatfs: always align malloc to lba
2024-03-12 15:43:44 +02:00
CTCaer
7d1600b85c
bdk: consolidate ffsystem into bdk
2024-03-12 15:16:18 +02:00
CTCaer
83ac40c4b9
bdk: rtc: handle offset adjustment in-place
2024-03-12 15:08:55 +02:00
CTCaer
4131ff12d7
bdk: sdram: adjust sdmmc1 la for l4t
2024-02-21 10:50:15 +02:00
CTCaer
9ea847578e
bdk: display: add another oem clone
2024-02-21 10:40:46 +02:00
CTCaer
6d69ef3cf6
bdk: sprintf: allow padding > 9
2024-02-16 16:01:54 +02:00
CTCaer
f05563579e
bdk: max77620: raise sd1 max voltage
...
For T210.
2024-02-16 15:55:40 +02:00
CTCaer
644747230c
bdk: dram: add FPGA code for 3rd gen micron
2024-02-16 15:54:22 +02:00
