Commit graph

445 commits

Author SHA1 Message Date
CTCaer
b01cc2432f bdk: irq: remove ack source
HW interrupts can't be managed by FIR.
Only actual hw can clear the interrupt.
2024-06-02 07:46:18 +03:00
CTCaer
05db43a97c bdk: hwinit: move down debug uart init 2024-06-02 07:44:22 +03:00
CTCaer
859811a154 bdk: fatfs: update copyright
Last edit was in 2022.
2024-06-02 07:42:35 +03:00
CTCaer
6b54c4a477 bdk: usb: hid: don't send a packet if no new data
Reduce the interrupt caused at the host side
2024-06-02 07:40:11 +03:00
CTCaer
9d79af231e bdk: use static where it should 2024-06-02 07:09:34 +03:00
CTCaer
84c5439c70 bdk: usb: utilize apb relaxed clocks for init 2024-06-02 07:01:31 +03:00
CTCaer
8c44969afb bdk: blz: refactor style 2024-06-02 06:51:47 +03:00
CTCaer
7a74761da9 bdk: bpmp: add and use bpmp_clk_rate_relaxed 2024-06-02 06:51:06 +03:00
CTCaer
14706cef4e bdk: minerva: add emc src div disable 2024-06-02 06:46:28 +03:00
CTCaer
93296c2c38 bdk: joycon: add packet size checks
Pass the real received data size and do the proper checks for minimum info.
2024-05-19 17:42:10 +03:00
CTCaer
a070d2e394 bdk: ums: allow real sizes for boot partitions
Since that's eMMC, do not clamp the size to 4MB.
That doesn't affect anything other than allowing the host to see the whole
physical partition .
2024-05-19 10:57:20 +03:00
CTCaer
927489d2da bdk: add missed defines 2024-05-19 10:50:25 +03:00
CTCaer
ae29f359ee bdk: hwinit: rename reinit_workaround to deinit 2024-05-19 10:49:25 +03:00
CTCaer
7af343dd6c bdk: input: make joycon detection more robust
There's a hw bug on the gpio controller that can latch the last value on reads.
Mitigate that by reading once to unlatch the input value.

Also actually allow sio to be polled every 8ms.
2024-05-19 10:19:25 +03:00
CTCaer
547a3542ee bdk: display: add more defines 2024-05-19 10:16:52 +03:00
CTCaer
4bc0a0591c bdk: display: wait 2us for bl pwm config to take
Fixes the tiny blink showing up while pwm is still at max.
2024-05-19 10:15:52 +03:00
CTCaer
985c513770 bdk: hwinit: add arbiter config 2024-05-19 10:07:06 +03:00
CTCaer
16eb6a3c44 bdk: types: do not overflow on byte swaps
Addresses warning message.
2024-04-25 16:57:43 +03:00
CTCaer
856994e4f4 bdk: sprintf: add right padding support 2024-04-25 04:56:38 +03:00
CTCaer
ec2e62236a bdk: pinmux: add i2s pin config 2024-04-25 04:52:13 +03:00
CTCaer
2648a2655c bdk: sdram: add info about custom 8GB T210 config
That's a suggestion on which 4GB modules are certainly fine to use.
2024-04-25 04:50:07 +03:00
CTCaer
62153fdfbb bdk: types: add likely/unlikely global macros 2024-04-25 04:48:09 +03:00
CTCaer
28960728f9 bdk: joycon: add bit numbers on the button struct 2024-04-25 04:46:27 +03:00
CTCaer
902ccede9a bdk: joycon: use proper bits for batt levels 2024-04-25 04:45:50 +03:00
CTCaer
96efa7a002 bdk: vic: add support for P8 and R5G5B5 2024-04-25 04:44:22 +03:00
CTCaer
d92906db5e bdk: display: correct some reg names and add more 2024-04-25 04:44:08 +03:00
CTCaer
e8d6516f43 bdk: display: use basic profile for OLED
That's the one with the accurate sRGB colors.
Anything else is over saturated.
2024-04-25 04:38:57 +03:00
CTCaer
a6727f6e32 bdk: display: update active regs on vsync for WinD
Doing that on hsync can cause issues on disable without actually syncing to it.
2024-04-25 04:38:04 +03:00
CTCaer
e846f4576e bdk: minerva: l4t: adjust sdmmc1 la and freq table
- LA is tightened up
- Copied frequencies are now 204/408/800/1333/1600/OC (from 204/666/800/1600/OC)
2024-03-29 13:21:53 +02:00
CTCaer
42c02e97e8 bdk: display: add 6.2" panel clone 2024-03-29 13:21:53 +02:00
CTCaer
d687b53249 bdk: heap: add zalloc and utilize it 2024-03-27 09:00:53 +02:00
CTCaer
9e41aa7759 bdk: smmu: refactor and update driver
- Allow ASID to be configured
- Allow 34-bit PAs
- Use special type for setting PDE/PTE config
- Initialize all pages as non accessible
- Add function for mapping 4MB regions directly
- Add SMMU heap reset function
- Correct address load OP to 32-bit and remove alignment on SMMU enable payload
- Refactor all defines
2024-03-14 09:21:06 +02:00
CTCaer
9ba7c44b89 bdk: clock: use real source clock dividers
Use CLK_SRC_DIV macro in order to have the actual divider showing.
2024-03-13 02:01:01 +02:00
CTCaer
9a520d63a6 bdk: smmu: refactor driver and allow other asid 2024-03-13 01:54:46 +02:00
CTCaer
20e661fc01 bdk: refactor flow control defines 2024-03-13 01:50:45 +02:00
CTCaer
3a4fa12f42 bdk: smmu: powergate ccplex after enabling smmu 2024-03-13 01:44:58 +02:00
CTCaer
fb31cb2926 bdk: ccplex: add no rst vector lock & powergating
Allow not locking the reset vectors and launch a new payload after powergating ccplex.
2024-03-13 01:37:52 +02:00
CTCaer
f126486266 bdk: sdmmc: utilize block size defines 2024-03-12 15:47:14 +02:00
CTCaer
25b7ffecd1 bdk: fatfs: always align malloc to lba 2024-03-12 15:43:44 +02:00
CTCaer
7d1600b85c bdk: consolidate ffsystem into bdk 2024-03-12 15:16:18 +02:00
CTCaer
83ac40c4b9 bdk: rtc: handle offset adjustment in-place 2024-03-12 15:08:55 +02:00
CTCaer
4131ff12d7 bdk: sdram: adjust sdmmc1 la for l4t 2024-02-21 10:50:15 +02:00
CTCaer
9ea847578e bdk: display: add another oem clone 2024-02-21 10:40:46 +02:00
CTCaer
6d69ef3cf6 bdk: sprintf: allow padding > 9 2024-02-16 16:01:54 +02:00
CTCaer
f05563579e bdk: max77620: raise sd1 max voltage
For T210.
2024-02-16 15:55:40 +02:00
CTCaer
644747230c bdk: dram: add FPGA code for 3rd gen micron 2024-02-16 15:54:22 +02:00
CTCaer
1f30b8deb7 bdk: minerva: add custom option in table 2024-02-16 15:51:02 +02:00
CTCaer
bfc6069b2d bdk: display: add OEM panel id 2024-02-14 00:08:06 +02:00
CTCaer
4576ed81ef sdram: acquire per chip mrr info 2024-02-12 04:08:39 +02:00
CTCaer
b37430dc1d bdk: update copyright year 2024-01-07 12:38:10 +02:00