| bootloader/screenshots/ | Folder where Nyx screenshots are saved |
| bootloader/payloads/ | For payloads. 'Payloads...' menu. Autoboot only supported by including them into an ini. All CFW bootloaders, tools, Linux payloads are supported. |
The bootloader can be configured via 'bootloader/hekate_ipl.ini' (if it is present on the SD card). Each ini section represents a boot entry, except for the special section 'config' that controls the global configuration.
| bootwait=3 | 0: Disable (It also disables bootlogo. Having **VOL-** pressed since injection goes to menu.), #: Time to wait for **VOL-** to enter menu. |
| verification=2 | 0: Disable Backup/Restore verification, 1: Sparse (block based, fast and not 100% reliable), 2: Full (sha256 based, slow and 100% reliable). |
| logopath={SD path} | If global customlogo is 1 and logopath empty, bootlogo.bmp will be used. If logopath exists, it will load the specified bitmap. |
| warmboot={SD path} | Replaces the warmboot binary |
| secmon={SD path} | Replaces the security monitor binary |
| kernel={SD path} | Replaces the kernel binary |
| kip1={SD path} | Replaces/Adds kernel initial process. Multiple can be set. |
| kip1={SD folder}/* | Loads every .kip/.kip1 inside a folder. Compatible with single kip1 keys. |
| fss0={SD path} | Takes a fusee-secondary binary and extracts all needed parts from it. |
| kip1patch=patchname | Enables a kip1 patch. Specify with multiple lines and/or as CSV. Current available patches nosigchk. |
| emummc_force_disable=1 | Disabled emuMMC if it's enabled. |
| stock=1 | Disables unneeded kernel patching when running stock or semi-stock. `If emuMMC is enabled, emummc_force_disabled=1` is required to run completely stock. |
| icon={SD path} | Force Nyx to use the icon defined here. If this is not found, it will check for a bmp named as the boot entry ([Test 2] -> `bootloader/res/Test 2.bmp`). Otherwise default will be used. |
**Note2**: When using FSS0 it parses exosphere, warmboot and all core kips. You can override the first 2 by using `secmon`/`warmboot` after defining `fss0`.
You can define `kip1` to load an extra kip or many via the wildcard (`/*`) usage.
**Warning**: Never define core kips when using `fss0` and make sure that the folder (when using `/*`), does not include them. This is in case the kips are incompatible between them.